iPhone X Camera Replacement

iPhone X Camera Replacement


Hello everyone, today I show you how to disassemble
iPhone X and replace camera module To disassemble the iPhone X you need the following
tools: • Screwdriver set
• Plastic mediator • Suction cup for removing display
• Tweezers and opening plastic tool • Hairdryer
In the description under this video, I left links to the necessary tools and parts for
replacement. Before disassembly, turn off the iPhone and
remove the sim card tray. Unscrew the two screws near the charging port
with a Pentalobe 0.8 mm screwdriver Take any hair dryer and heat the surface of
the screen for 1-2 minutes. Set the suction cup at the bottom of the screen
and pull the ring up. Next, take a plastic mediator and begin to
disconnect the display module from the iPhone. The case of the iPhone 10 opening like a book. Open the display to the right side. Using a Tri-Wing 0.6mm screwdriver, unscrew
5 screws and remove the metal panel. Under the metal panel, you will see cables. The first is disconnecting the battery cable,
and then disconnecting the 3 display cables. To replace the main camera on the iPhone X
you need to unscrew the 2 screws and remove the metal panel. Disconnect the two cables from the mainboard
and now you can remove the camera from the smartphone case. In the description under the video, you will
find a link where you can buy a new camera for iPhone X
Install the camera in the iPhone case. Now install the metal frame and fasten 2 screws. Connect two camera cables to the motherboard
and now you can check the camera before final assembly of the iPhone. To test the iPhone, you need to connect 3
display cables and after the battery cable. Turn over the display, but do not close the
case, just flip it. Turn on the iPhone and check how the smartphone
works. If everything is working properly, let’s begin
to the final assembling. Remove old glue from iPhone X case
Using medical alcohol, wipe the iPhone X case from the old adhesive tape. If you want to restore the water resistance
of your iPhone X, you need adhesive tape like this. Of course, you can assemble your iPhone X
without this adhesive tape, but this makes no sense because this adhesive tape costs
only a couple of dollars. In the description under the video, you find
a link where to buy this adhesive tape. Connect 3 display cables to the mainboard
and only after connect the battery cable. Install the metal panel and fasten the screws. Turn over the display and press it to the
case. Fasten the 2 screws near the charging port. Install the tray with a sim card. Now you can turn on your iPhone X and use
it

2 thoughts on “iPhone X Camera Replacement

  1. **links to the camera module for iPhone X and screwdrivers for disassembly in the description under the video

  2. Is it possible to upgrade graphic card in asus x556ua?

Leave a Reply

Your email address will not be published. Required fields are marked *